Stationary TEHNOLINK Load Bank

TEHNOLINK offers a Load Bank models that are robust, broad-spectrum power (50kW¸1000kW) and specially designed for working in outdoor conditions. STLB (Stationary TEHNOLINK Load Bank) sets high standards with intelligent control management, high protective measures, adjustable step loads and effortless installation.

STLB is an excellent economical solution for regular testing carried out in order to check the work of the diesel engine as well as during the critical commissioning them. Load Bank is a device that represents a continuous power source and the load at which all the energy received from the source dissipates. Load obtained by this type Load Bank-a fully active ie. cosf = 1 so if your needs are different, it is necessary to consider another model STLB.

The role of a Load Bank is presented in the form of support during operation, testing and protection of the power supply. Application of Load Bank's impossible to WET STACK-ING engine or phenomena that occur when unburned fuel due to a light load preserve engine performance.

  • The waterproof construction (degree of protection IP23)
  • Designed for continuous operation without the need for a cool-down period
  • The resistor elements are protected by fuses that do not allow catastrophic consequences
  • Intelligent protection solutions, indications of problems and operational control

Cabinet Construction

Construction STLB cabinet is made of galvanized steel with a very high quality of the final painting and external covers made of stainless steel. All installations (power, motor and control) are located in the sealed part of the cabinet which has a thermostat to the impact of adverse effects is kept to a minimum. Horizontal and vertical air flow is optional. Cabinet housing likewise is intended for mounting on the roofs of buildings, residential and commercial buildings, the tops of buildings or concrete surfaces. Easy portability and installation enabled the expansion of the bottom of the chassis

Remote control and alarms

  • Air-Flow control
  • Over-Temperature
  • Load Dump
  • Automatic Load Dump


If the Load Bank is connected in parallel with the network and then the engine via a current transformer observe how the load aggregate and depending on its value does not allow that the unit is loaded with less than 40%. Automatic Load controller represents a sophisticated controller that adds and subtracts genset load depending on its current term exposure and all in order to preserve engine performance as part of the genset drive power due to light load. The controller adds a load in specified increments  steps depending on Load Bank's  power.


Within each STLB is EMERGENCY STOP that allows the user at any time to terminate the operation of Load Bank in a case of unforeseen situations. Protective elements  are providing adequate protection to possible short circuit. Visual indication of the distribution cabinet Load Bank in unforeseen situations (Motor Overload, Air-Flow failure, Over-Temperature) prevents the user to manually start the Load Bank's.


  • Emergency stop (E-STOP)
  • Start/Stop fan switch
  • Main switch On/Off
  • Master Load ON/OFF switch
  • Individual Load Step ON/OFF switch
  • Fault condition indicators (indications of contingencies)
  • Normal Condition indicators


Cooling System STLB type active / reactive resistive elements represents more coolers which are arranged in the active or reactive chamber. The amount of air intake must always be prepared satisfy the needs of heaters in order not to cause breakdown.

The consequences of non-use TEHNOLINK Load Bank

  • Unburned fuel promotes the destruction of the engine block
  • Excessive oil consumption
  • Reduced efficiency and motor power
  • Reduced output power generator
  • Increased emissions
  • Early repair of the engine block
  • Increased maintenance costs of the engine block

Application of TehnoLink Load Bank-a

  • UPS systems
  • Diesel Generators
  • Plane power generators
  • Wind generators
  • Hydro generators
  • Energy recuperations

In the modern world where a temporary or permanent interruption of power represents a major economic loss or liabilities and needs of each facility, factory or office is certainly the existence of the reserve power supply. TEHNOLINK genset emerge as the ultimate solution. As  currently the only domestic manufacturers of diesel genset as well as the quality of our production and reliability of their work is imperative. In order to offer our customers additional support gensets, our team of experts presents a modern solution for protection of diesel generators. PTLB (TEHNOLINK Portable Load Bank) is a completely innovative and superior solution to the problem of light load diesel engines. As we do not want to allow our customers light load of genset in any part of the day occur much bigger problems with the drive motor, we offer a solution that will impose a load  at least 40% of nominal at a time when it is needed. The constant progress, innovative ideas and cutting edge technical solutions represents constant goal of all  TEHNOLINK workers so if you want a secure income and peace of mind, please contact us.